DEKI/ENGINE 문서
매뉴얼 API 참조
Deki 0.40.1
비주얼 에디터가 있는 2D·3D 모듈식 C++ 엔진
로딩중...
검색중...
일치하는것 없음
LilyGO T-Display S3 AMOLED

이 가이드는 아직 번역되지 않았습니다.

A slim device with a bright 1.91 inch AMOLED screen, with or without touch.

LilyGO T-Display S3 AMOLED

사양

항목 내용
프로세서 ESP32-S3
CPU 속도 240 MHz
플래시 16 MB
RAM 8 MB
화면 536 x 240, 1.91 in
색상 형식 RGB565
기타 Wi-Fi, Bluetooth

이 디바이스 사용하기

  1. 패키지 관리자 에서 deki-lilygo-boards 를 설치합니다.
  2. In the 빌드 패널, choose LilyGO T-Display S3 AMOLED.
  3. 빌드 후 플래시 를 누릅니다.

What is set up for you

Display and touch.

Good to know

  • There is no SD card slot, so your game's assets are always in the flash: about 13 MB of the 16 MB.
  • An AMOLED has no backlight. Brightness is a command to the panel, which Deki sends when the screen turns off and on.
  • On the version without touch, nothing answers and the boot is not slowed by it.
  • If the device does not show up as a port, hold BOOT, press RESET and release BOOT.

Pins

Part Pins
Panel power GPIO 38
Quad SPI bus SCK 47, IO0 18, IO1 7, IO2 48, IO3 5
Display (RM67162) CS 6, reset 17
I2C bus SDA 3, SCL 2
Touch (CST816T) Address 0x15, interrupt 21